Case Study: My Experience With Services

Crown Moulding, a Way to Decorate Your Home or Office Crown moulding is defined as a decorative piece of wood, metal, or plaster that is used to accentuate some places in your home or office. This decorative material can be used either on the exterior or interior of your home or office. Mouldings are installed to frame the walls, ceilings, windows, and door openings of your home or offices. A crown moulding can be used as your decorative trim from wall to ceiling thus adding beauty to any space or room. Look at the importance of crown moulding to your choice of framing an expensive work of art. It is important to choose your crown moulding in relation to the design of your home to avoid negative attention. Be careful not to choose the design of your crown moulding to be not too simple or not too big or small so as not to cheapen the area where it is installed. Some homeowners would go for custom made crown moulding to settle the look of their interiors and personal style. Crown moulding is generally installed along the seams where the wall meets the ceiling in a room.
If You Read One Article About Services, Read This One
Your home or office will have an increased value, glamour and beauty if you install crown moulding.
If You Read One Article About Services, Read This One
There are some preparations to take before you install your crown moulding. Your number one guideline is to locate all the studs in the ceiling joist and walls. You can do this by making some light pencil marks at the point where you see the crown moulding up as you nail it. The next step is to find out which way the ceiling joists are running. The importance of this is because you have only the nailers for the top of the moulding on two of the four walls, if your room is a square. Another easy way to find the size of your triangle nailer is a framing square. You can still work effectively even if the nailer does not perfectly fit. The next advice is not to have the nailer forcing your moulding not to sit flush against the wall and ceiling by leaving a little room. Next preparation is to install the nailers on the walls without the ceiling nailers. Position the nailer against the wall and ceiling, then pre-drill the nailer using a counter sink drill bit into the studs on the walls. Afterwards, use a 3 inches coarse thread drywall screw for attaching to the stud. Another pointer is putting a reference line on the wall at the height you would want the moulding to sit on the wall. This can be done by taking a piece of scrap moulding, place it against the wall and ceiling in a proper way, and then writing lightly on the wall with a pencil at the bottom of the moulding.